When new copper pipe is installed you must wait 60 days prior to install. Because the new copper pipe has the potential of leaching copper into the water until it has a chance to build up a patina. The time required for this varies greatly from a few days to 60 days depending on water chemistry and how much damage was done to the plumbing system by the excessive use of corrosive flux in the soldering process. New Copper Pipe Installation The seed crystals that are produced by the media will continue to grow or partially re-dissolve depending on changes of Langelier Saturation Index of the water. Temperature is one of five parameters that are factors in LSI. Temperature Water Chemistry Requirements Hardness: 0 - 75 GPG Temperature: 36 – 122˚F (2 - 50˚C) Pressure: 40-100 psi Iron: 0.0 ppm Sulphur: 0.0 ppm Manganese: 0.0 ppm Phosphate: 0.0 ppm Soft-Tec® Scale Control Testing Soft-Tec® used the testing protocol of DVGW through an independent laboratory. DVGW is recognized throughout Europe like the National Sanitation Foundation (NSF) in North America. The test was done by running raw 20gpg hardness water at 80˚C for continuous 21 days and then water with same properties treated by Soft-Tec® media was ran for 21 days. The comparison of Calcium scale proves the proficiency more than 99%. 21 Days Soft-Tec® Treated Water 21 Days Raw Water (20gpg) Soft-Tec® Benefits No additional water, chemicals or salt required No electricity cost No operating cost Essential body nutrients in your water remain intact Environmentally friendly, no salt required In the first 90 days make sure your dishwasher drying cycle is turned off and you're using rinse agent to assist in scale control from the hot water tank. Always use phosphate free dishwashing detergent. Dishwasher Operation
RkJQdWJsaXNoZXIy NTc4ODc=