7 REVERSE OSMOSIS INSTALLATION AND USER GUIDE BARRIE ● ONTARIO ● CANADA 705.733.8900 WWW.EXCALIBURWATER.COM Drinking Faucet Reverse Osmosis faucet should be placed near the sink where drinking water is normally obtained. Convenience of use (filling of water pitchers and glasses), and an open area beneath the Reverse Osmosis faucet under the sink for attaching product and Reverse Osmosis drain tubing are considerations. A 2" diameter flat surface is required above and below the Reverse Osmosis installation site. Holding Tank The Reverse Osmosis Holding Tank may be placed where it is convenient within 10 feet of the Reverse Osmosis faucet; under the sink, in an adjacent cabinet are the best choices or in a basement within 20 feet of the Reverse Osmosis faucet. If a longer run of Reverse Osmosis tubing is required, a transfer delivery pump may be required extra to boost line pressure. Manifold Assembly The Reverse Osmosis manifold can be installed on either the right or left side of the under-sink area or a cabinet. The right side is recommended because all the Reverse Osmosis tubing will be to the back of the cabinet and out of the way. Reverse Osmosis Installation in the basement is also an option; one location is near the laundry/utility sink where cold potable water and rain access are handy. The mounting location should allow adequate clearance and accessibility for Reverse Osmosis cartridge changes. Feed Water Connection The feed water has the option of angle valve adapter or self-piercing saddle valve. The Reverse Osmosis Feed Water Saddle Valve should be located as close to the manifold assembly as possible. The angle valve adapter should be mounted over the faucet supply valve. USE A POTABLE COLD WATER SUPPLY ONLY TO YOUR REVERSE OSMOSIS SYSTEM. Softened water is preferred as it will extend the life of the Reverse Osmosis Membrane. Drain Line Connection The Reverse Osmosis waste water must go to a drain connection with easy access. Do NOT connect the Reverse Osmosis system drain line to the dishwasher drain or near the garbage disposal. Installation Instructions All plumbing should be done in accordance with local plumbing codes. In restricted under-sink areas, it may be easier to install the Reverse Osmosis faucet first. Allow adequate Reverse Osmosis tubing lengths for any final Reverse Osmosis component position. Push to Connect Fittings Assembly: - Cut the tube straight at the end and push the tubing into the grey collar. Disassembly: - Push the grey release button and pull the tube out.
RkJQdWJsaXNoZXIy NTc4ODc=