15 REVERSE OSMOSIS INSTALLATION AND USER GUIDE BARRIE ● ONTARIO ● CANADA 705.733.8900 WWW.EXCALIBURWATER.COM • Open the Reverse Osmosis dispensing faucet by lifting the handle and open the Reverse Osmosis Holding Tank Shut-Off Valve (the handle should be parallel with the valve body). • Once all the pressure has been released, remove the Reverse Osmosis Housing on the side of the manifold labeled "SEDIMENT". Pour one capful of bleach (this is approximately 2 tsp. or 10 ml) into one of the white Housings. Engage and firmly tighten the Reverse Osmosis Housing hand tight only. • Remove all Reverse Osmosis Housings add one capful of bleach in each. Engage and firmly tighten the Housings hand tight only. • Slowly open the Reverse Osmosis Feed Water Valve (turning counter clockwise). • As soon as the water begins to come out of the Reverse Osmosis Dispensing Faucet, close the Faucet. • Let stand for 15 minutes. NOTE: During this time, check the Reverse Osmosis system carefully for leaks. • At the end of 15 minutes, CLOSE the Reverse Osmosis Feed Water Ball Valve and open the Reverse Osmosis Dispensing Faucet. Allow the Reverse Osmosis Holding Tank to completely drain. • Fully close the feed water valve and then remove the Reverse Osmosis Activated Carbon Pre-filter Housing and install the Reverse Osmosis activated Carbon Pre-filter. • Firmly tighten the Reverse Osmosis Housing hand tight only. Rinsing the Reverse Osmosis System • Slowly open the Reverse Osmosis Feed Water Saddle Valve fully counter clockwise. • The Reverse Osmosis Holding Tank Valve should be open. The Reverse Osmosis System is now making water. • When the storage tank is full, open the faucet and fully drain the storage tank and repeat this step again. • Discard the water of first two full storage tank.
RkJQdWJsaXNoZXIy NTc4ODc=