Angle Valve Adapter REMOTE INSTALLATION (requires nearby water source and drain) STEP ONE – INSTALL ANGLE VALVE ADAPTER 1 Identify the cold water line in the sink cabinet. Turn off the cold water supply to the sink. 2 Turn on the kitchen faucet to release pressure and allow water to completely drain from the line. 3 Disconnect the cold water line from the lower shut off valve. Note: You may need to shorten the supply line pipe using a hacksaw or pipe cutter to accommodate the Adapter if pipe is rigid. 4 Holding the Angle Valve Adapter in an upright position (see diagram in Package Contents on page 1), screw onto the threaded shut off valve. 5 Screw the cold water supply line to the male threads of the Adapter using the nut that was previously connecting the cold water line to the shut off valve. System should be supplied only with cold water ONLY. 2” Minimum Tube to Drain Point Tube to Tank Tube to Faucet 3
RkJQdWJsaXNoZXIy NTc4ODc=