2 FILTER INSTALLATION AND USER GUIDE BARRIE • ONTARIO • CANADA 705.733.8900 WWW.EXCALIBURWATER.COM 1) INSTALLATION Pre-installation instructions The cycle times, sequence of cycles and filtration capacity are preset to default by Excalibur. The dealer must guide the installer to change the values according to the water quality, day override and time of regeneration. WATER TEST Hardness gpg Iron ppm pH number Nitrates ppm Manganese ppm Sulphur yes/no Total Dissolved Solids General Installation and Service Warnings • The filter is designed so that it can be installed easily with minor plumbing changes on existing plumbing. • The piping must be clamped properly and the weight of the plumbing must not be on the Filter. • Do not use any kind of lubricant including silicone. A silicone based lubricant can be only used on O-Rings but not necessary. • The nuts and caps can be fastened and unfastened by hand or the plastic service wrench. Do not use pipe wrench to tighten the caps and nuts. Site Requirements • Water Pressure: - 40-110 psi • Water Temperature: - 40-110°F (4.4-43°C) • Electrical- 115/120 V, 60Hz Uninterrupted Outlet • Current required is 0.5 Amperes • The plug-in transformer is for dry locations only • The tank should be on a firm level surface
RkJQdWJsaXNoZXIy NTc4ODc=