Angle Valve Adapter REMOTE INSTALLATION (requires nearby water source and drain) STEP ONE – INSTALL ANGLE VALVE ADAPTER 1 Identify the cold water line in the sink cabinet. Turn off the cold water supply to the sink. 2 Turn on the kitchen faucet to release pressure and allow water to completely drain from the line. 3 Disconnect the cold water line from the lower shut off valve. Note: You may need to shorten the supply line pipe using a hacksaw or pipe cutter to accommodate the Adapter if pipe is rigid. 4 Holding the Angle Valve Adapter in an upright position (see diagram in Package Contents on page 1), screw onto the threaded shut off valve. 5 Screw the cold water supply line to the male threads of the Adapter using the nut that was previously connecting the cold water line to the shut off valve. 3/8”White Tube to Faucet 2” Minimum 1/4”White Tube to Drain Point 3/8”White Tube to Tank 3
RkJQdWJsaXNoZXIy NTc4ODc=