STEP TWO – INSTALL RO DRAIN CONNECTOR 1 Identify drain outlet location. 2 From back of foam seal, remove protective cover. 3 Knock center hole out, align holes, and attach to front plate of drain connector. 4 Allowing room for drilling, position the drain connector on sink drain pipe above drain trap. 5 Securely tighten nuts and screws. 6 Using drain connector port as drill guide, drill 7/32” hole through wall of drain pipe. Be sure not to penetrate opposite side of pipe, and be careful not to damage side of drain port fitting. STEP THREE – INSTALL RO FILTER ASSEMBLY 1 Select easily accessible area under sink to mount system manifold. Note: Allow 4-6” clearance below the filter to the floor to allow ample space for filter changes. 2 Mark holes for mounting screws using built-in bracket on back of manifold. 3 Drill two pilot holes for mounting brackets using 1/8” drill bit.* 4 Insert mounting screws into the wall leaving approximately 3/8” of each screw exposed. 5 Hang manifold on mounting screws. 4 WARNING Be sure that all electrical appliances and outlets are turned off at the circuit breaker before working in the cabinet area. ! CAUTION Please wear safety glasses to protect eyes when drilling. ! CAUTION ! Use caution not to drill into anything beyond the cabinet wall. * Angle Valve Adapter
RkJQdWJsaXNoZXIy NTc4ODc=