STEP SIX – CONNECT TUBING Install tubing for water supply line from angle valve adapter to manifold inlet. Note: Do not bend or crimp tubing during this step. 1 With utility knife, cut the 1/4" white tubing squarely to desired length. 2 With water, wet one end of tubing and push into the angle valve adapter approximately 5/8” until it stops. 3 Wet other end of tubing and push into the manifold “INLET” approximately 5/8” until it stops. Note: It is not necessary to remove tubing for routine maintenance and filter exchanges, however, it may easily be disconnected if necessary. To disconnect, turn off water supply to system and press in white collar around fitting while pulling tubing out with other hand. Install tubing for water supply line frommanifold outlet to faucet. 1 Identify length of 3/8”white tubing necessary to connect to manifold outlet labeled “FAUCET” to faucet adapter. 2 Cut tubing squarely with utility knife. Do not discard remaining tubing. 3 With water, wet one end of tubing and push into manifold outlet labeled “FAUCET” approximately 5/8” until it stops. 4 With water, wet other end of tubing, push into faucet adapter approximately 5/8” until it stops. Connect tubing frommanifold to tank. 1 Use remaining white tubing set aside earlier and identify length needed to connect tank outlet labeled “TANK” on manifold to tank. 2 Cut white tubing square with a utility knife. 3 Insert tubing into port of tank valve (previously connected to tank) and tighten tank valve nut. 4 Insert other end of white tubing into outlet of manifold labeled “TANK” approximately 5/8” until it stops. Note: For servicing, tubing lengths should allow for removal of assembly frommount screws. 6
RkJQdWJsaXNoZXIy NTc4ODc=