10 Installation of Quick Connector 3.1 Quick connector ports are adopted on the inlet and outlet of the RO system. Quick connector is a port which can connect quickly and firmly without any tools. Firstly,pull out the Ω type clip on the port,push the movable plastic ring to the port,make it attaching to the port to move the plastic plunge or PE pipe. Insert the PE pipe to the end of the port,then pull slightly to make a gap between the movable plastic ring and the port. Finally insert the Ω type clip in the gap. When taking the PE pipe from quick connector,first pull out the Ω type clip,push the movable plastic ring to the port to make it attaching the port,then could pull out the PE pipe. 3.2 Divide and Connect of PE pipe and quick connector Connect:Take down Ω type clip,cut the PE pipe to a smooth end face and insert into the quick connector,then pull slightly to check PE pipe has been in the o ring seal of quick connector,finally insert the clip. Divide:Take down Ω type clip,make the plastic ring attaching to the port,pull out the PE pipe.
RkJQdWJsaXNoZXIy NTc4ODc=