STEP SIX – CONNECT TUBING (Continued) Connect Flow Restrictor to Membrane Housing. 1 Locate membrane drain port on lower membrane side. 2 By pushing down on the collar while pulling plug with other hand, remove black plug from membrane Rlter drain port. 3 Identify length necessary to connect to drain port to Sow restrictor. 4 With utility knife, cut the tubing squarely to desired length. 5 Insert restrictor into end of tubing. 6 Insert tubing into Rtting on bottom of membrane Rlter approximately 5/8” until it stops. 7 Gently tug on tubing to ensure it is Rrmly seated in Rtting. Connect Tube from Flow Restrictor to Drain Adapter. 1 Attach tubing to Sow restrictor. 2 Cut enough tubing to route in as straight as possible without any twists, kinks, loops or valleys. 3 Cut end of tubing with utility knife. 4 Insert into Rtting approximately 1” until it stops. 5 Gently tug on white tubing to ensure it is Rrmly seated in Rtting. Angle Valve Adapter Tank Valve Tube to Membrane Drain Pre Filter Post Filter Tube to Filter Tube to Tank Tube to Faucet Tube to Drain 7
RkJQdWJsaXNoZXIy NTc4ODc=