9 SCALE CONTROL CONDITIONER INSTALLATION AND USER GUIDE BARRIE ● ONTARIO ● CANADA 705.733.8900 WWW.EXCALIBURWATER.COM 4) SERVICE INSTRUCTIONS 4.1) Media Replacement Step 1: - Shut the inlet water supply off. Step 2: - Open the faucet downstream of the filter to release the pressure and then shut off the faucet. Step 3: - Turn the bypass valve handles outwards to bypass operation. Step 4: - Loosen the bypass valve – tank connections and keep the bypass valve installed on plumbing. Step 5: - Slowly open the water supply valve, if supply water is needed in house. Step 6: - Loosen and remove the tank head by rotating it counterclockwise. Step 7: - Pour the tank water into the drain and use some type of screen to prevent the media particles going to the drain. Step 8: - Rinse the tank with water. Step 9: - Place the distributor in the bottom center rim and plug the distributor tube opening with rag or tape. (Soft-Tec® distributors are equipped with flow control so do not replace the distributor tube) Step 10: - Use a funnel or other device to pour the appropriate quantity of media into the tank. Step 11: - Load the appropriate quantity of FlexBed into the tank. Step 12: - Fasten the tank head after inserting the distributor tube into the in-out head. Make sure the tank is vertically straight if not level the surface properly. Step 13: - Fasten the bypass valve connections. Step 14: - Follow the start-up instructions given in this manual.
RkJQdWJsaXNoZXIy NTc4ODc=