6 SCALE CONTROL CONDITIONER INSTALLATION AND USER GUIDE BARRIE ● ONTARIO ● CANADA 705.733.8900 WWW.EXCALIBURWATER.COM 2.11) Installation Instructions 1) The water heater’s inlet must be at least 10ft away from conditioner. 2) The unit must be located in a room temperature above 33° F. 3) If vacuum occurrence is expected, then the vacuum breaker must be installed at the inlet of the conditioner 4) The unit must not be exposed to direct sunlight. Ultraviolet rays can damage the system 5) The primer, solder or solder flux must not get on the O-rings while installation. 6) After soldering the lines must be cooled before installing the O-Rings, nuts and caps. 7) If the electrical system is grounded to the plumbing, then a copper strap must be connected between inlet and outlet as shown in figure. 8) The plumbing must be done by following the local plumbing codes. 9) Do not install any device, downstream of Soft-Tec® which requires removal of scale. 10) Do not install any anti-scalant upflow of the Soft-Tec® system. 11) Soft-Tec® system must always be the last stage of treatment chain. 12) If heavy dirt and debris has been tested or expected in future, then 20-micron sediment filter should be installed in pre-treatment. 13) If booster pump is required always install the pump upstream of the system. Installer Notes: 1) The Soft-Tec® systems are supposed to be very light weight as compared to conventional softeners. 2) Follow the installation drawing for plumbing instructions. 3) The system must be installed vertically straight but can be shipped in any orientation. 3) SPECIFICATIONS Model Number1 Mineral Tank Media ft3 (Liters) Flow Space Required Shipping Weight Dia X Height Soft-Tec® FlexBed GPM (LPS) LxWxH LBS EWS NSP0844 8X44 0.13 (4) 0.08 (2.3) 10.0 (0.63) 14x9x48 25 EWS NSB0844 8x44 0.13 (4) 0.08 (2.3) 10.0 (0.63) 14x9x48 27 1: - EWS NSP0844 is Premium Model and EWS NSB0844 is Superior Model
RkJQdWJsaXNoZXIy NTc4ODc=